This is our new Remote Switch with a built in 2 Channel 5.3v Regulator. Designed for use with 6.6v A123/Life and 2s 7.4v Lipo Batteries, this unit will direct all Battery power to the Rx via 2 x 6" Male to Male, 22AWG Servo Connectors. Simply plug into any 2 Channels on your Rx (Rudder and Gryo Gain suggested), then connect those specific plugs onto the unit for either Direct Voltage (High Voltage setups), or Regulated 5.3v.
A bright Red LED mounted on the unit will give visual verification of power status.
You can use the Remote Switch feature several different ways. Use the actuator on the side of the board to turn the unit on and off, or turn the switch to the on position and use your Spektrum Bind-Plug on the pins. With the plug inserted on the pins, the unit is off, pull the Plug off and the unit turns on. Have an old "Pin Flag" setup? Simply replace the female lead to a male lead and it too can be used to turn the unit on and off. Not using Spektrum and don't have a Bind Plug? We do, check out the Accessories Section.
Our Remote Switch is a "Fail-Safe" design that fails in the on position.
Unit comes packaged with 2 x 6" Male to Male, 22AWG Servo Extensions.
|Suggested Input Voltage:||2s - 7.4v / A123 / Life-6.6v|
|Regulated 5.3v Current Capacity:||3A|
|Length of RX Lead Plugs:||6"|
|Length of Battery Input Lead Plug:||4"|
|Plug Type:||No Connector - Pre-Tinned Wire|
|Size:||39mm x 26mm x 10mm|
* not intended for use between flight packs and esc's on electric aircraft
* do not leave battery connected to switch for long periods of no-use.
Safe Switch Duo
- Brand: Perfect Regulators
- Product Code: prr-rmtsw5v
- Availability: Backordered